![]() The current version of ULx for LabVIEW supports versions 2010 through 2021 both 32-bit and 64-bit. ![]() The warning can be ignored and will go away once you have saved your work to a new location. Next, a lot of the initial ULx for LabVIEW development work used LabVIEW 8.5 and because of this, you may see file path warning indicating that your path structure is different. ![]() Reading of the cb.cfg system file happens once when LabVIEW is started, not when you drop the first VI on your block diagram. If left open, ULx for LabVIEW is unaware of the changes you've made. This is important because when LabVIEW is started, it loads an MCC dll that reads this file. InstaCal will create/update the system cb.cfg file when it is closed. Make sure to close InstaCal before starting LabVIEW, I'll explain. The ULx for LabVIEW support requires that the device be configured with InstaCal before starting LabVIEW itself. Since I feel that I am not the only one with these problems, I hope that you guys can suggest a fix. This software was advertised as easy to use but there seems to be no documentation. I am pretty unhappy as this cost more time than exspected. I just found a download link to an updated version of the Ulx software but it was broken - so help in this forum did not help me so far either.Ī call with the service hotline did not help either as the guy only said that everything should work properly - to my bad, no detailed help. I checked the whole problem with 4 different distributions of LabVIEW (see titel) but had not success. However, I was able to detect the device in the device manager and reading it with DAQami worked just fine.Īfter research, I tested, if I did not run Instacal correctly but it worked fine. I know that MCC interfaces do not appear on NI MAX. I only stubled upon an error stating that the ULx software was only made for LabVIEW 8.5 and no other version. I have a USB-2408 device with a TC connected.Īfter setting up a simple read and display program in LabVIEW, I was not able to detect any device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |